1000W AC Servo Motor, 4 Nm, 2500 rpm

Brushless design 1kW AC servo motor, 2500rpm low speed, rated torque of 4 Nm, peak torque up to 10 Nm. Industrial servo motor is suitable for a wide range of automation equipment and instruments in the field of motion control.

Basic Specifications

• Model: SOCOJE80SY-M04025
• Matched Drive Model: SOCOJE-SG-AS302600
• Rated Power: 1000 W
• Rated Voltage: Single phase or three phase 220V AC
• Rated Current: 4.2 A
• Rated Speed: 2500 rpm
• Max Speed: 3000 rpm
• Rated Torque: 4 Nm
• Peak Torque: 10 Nm
• Square Flange Size: 80 mm
• Weight: 3.8 kg

Technical Parameters

• Number of Poles: 4 pairs
• Rotor Inertia:2.8 x10^-4 Kg.m²
• Brake Voltage: 24V DC (Non polar requirement)
• Incremental Encoder Line: 2500/5000 PPR (Optional)
• Absolute Encoder: 17 bit, 23 bit (Optional)
• Insulation Class: Class B
• Insulation and Voltage Resistance: 1500V AC, 1 Min
• Protection Grade: IP54

Features

1. Accuracy: SOCOJE AC servo motors realize closed-loop control of position, speed and torque, overcome the problem of stepper motor out-of-step.
2. Speed: Good high-speed performance, rated speed can reach 1000-3000 rpm.
3. Adaptability: SOCOJE heavy duty servo motors with strong anti-overload capability, able to withstand a load three times the rated torque, especially suitable for occasions with instant load fluctuations and requiring quick start.
4. Stable: Our AC brushless servo motors have smooth low-speed operation, no stepping phenomenon similar to stepper motor will occur when running at low speed, suitable for occasions occasions requiring fast response.
5. Timeliness: The dynamic response time of motor acceleration and deceleration is short, generally within tens of milliseconds.
6. Safety: SOCOJE AC servo motor protection grade is IP65, which meets the waterproof and dustproof requirements.

Installation Dimension (unit: mm)

Servo Motor without Brake Dimension

L (Incremental/Absolute encoder): 197mm

Servo Motor with Brake Dimension

L (with brake): 237mm

Note:

*All above is the standard installation dimension, can be changed according to the customers' requirments.
*Not hit the shaft, or the encoder in the other end would be damaged.

Details

Winding and Encoder Connection

Tips: Servo motor does not run when the pulse is output, how to solve?

1. Monitor the current pulse output value of controller and check if pulse output indicator lamp flashes to confirm that the controller has performed command pulse and has output pulse normally.
2. Check if the control cable, power cable, encoder cable between controller and driver are matched incorrectly damaged or contacted poorly.
3. Check if the brake of servo motor equipped with brake has been turned on.
4. Monitor the panel of servo driver to confirm if the pulse command has been input.
5. Run command is normal.
6. For control mode, always choose position control mode.
7. Check if the type of input pulse set by servo driver matches with that of command pulse.
8. Ensure that positive side drive prohibition, negative side drive prohibition signals and deviation counter reset signal are not input and the servo motor runs normally if load is removed, then check the mechanical system.